A robot arm on a test stand moving one joint at a time through a slow self-check

Newsroom / MA Reflex

A robot that sets itself up

No description file to write, no calibration day. In simulation, a robot arm nobody described set itself up on its own.

Before a robot can learn a job, someone usually has to describe the robot: its joints, their units and limits, the tool frame, the gripper. That description is written by hand and checked over a calibration day. MA Reflex removes the step.

The robot works out its own body

Connect a robot arm nobody described and MA Reflex works out its own body: joints, units, tool frame and gripper stroke. The arm runs through a short self-check, and MA Reflex works out the rest.

to set itself up, measured in simulation
193–296 s
budget, met on every arm
300 s
simulated models of commercial arms
3

Inside five minutes

Measured in simulation, on simulated models of three commercial arms, self-setup took 193 to 296 seconds, inside a five-minute budget. No description file was written and no calibration day was spent.

Then the job

Once the arm has set itself up, an operator shows the job once. MA Reflex practices it, repeats it at new layouts and carries it to another robot, with every action passing the safety gate. A changeover stops being a project.

Put autonomy to work.

Tell us what your machines need to learn on the job.